> FiiO E10K Portable Desktop Headphone AMP/DAC with Astell&Kern (iRiver)

FiiO E10K Portable Desktop Headphone AMP/DAC with Astell&Kern (iRiver) ICP-AT1000 Dynamic Driver in-Ear Monitor Headphones from Astell&Kern by Final Audio Design

Product Code:BT-42426704

Product weight:0.62 Pounds

Our Price:

PKR 40838.00

Quantity

add to card

Order Now

Astell&Kern(iRiver) AT 1000 In Ear Earphones by Final Audio Design with FiiO E10K Portable Headphone AMP/DAC

The E10K USB DAC Headphone Amplifier from Fiio is designed to improve your laptop s audio output quality via its PCM5102 DAC chip and is capable of handling PCM files in up to 24-bit, 96 kHz resolution. It features a selectable bass boost and low-pass filter, both with circuitry optimized for a low noise floor when engaged, allowing you to customize the sound of your audio to your tastes.

The unit connects to your laptop via its Micro USB connection, which also provides it with power. It offers a variety of connections, including a front-panel 1/8" headphone jack, a rear-panel 1/8" line output, and a rear-panel coaxial digital output, which allows you to send your digital audio to another destination.

AT1000 Earphones
Powered and tuned by the experts at Final Audio Design, the AT1000 is iRiver s entry level earphone. Equipped with a 8.5mm moving coil single dynamic driver, the AT1000 delivers powerful sound and are compatible with almost any kind of music playback device.

Along with Final Audio s BAM (Balancing Air Movement) technology that optimizes airflow inside the housing and efficiently controls unwanted vibrations that brings a deep and rich listening experience, the AT1000 brings clear bass response and smooth treble with a discernible mids at a very affordable price. Equipped with touch noise eliminating cables with built-in mic and 4-pole 3.5mm TRRS jack, take and make phone calls with the AT1000!

The E10K uses a PCM5102 internal DAC chip and can handle PCM files up to 24-bit/96 kHz while improving audio quality through via a linear internal filter, reduced delay and internal silence on changing tracks, and no phase shifts (Recommended Headphone Impedance: 16 to 150 Ω)

The E10K features a LMH6643 op amp, which is designed for transient response and driving powertilizes an OPA1642 as the voltage pre-amplifier and an AD8397 power amplifier to deliver a maximum power output of 450 mW at 16Ω (270 mW at 32 Ω) with a frequency response of 20 to 20,000 Hz, a signal-to-noise ratio of equal to or greater than 108 dB, and a T.H.D. of less than 0.004% into loads between 16 and 150Ω.

Astell&Kern iriver ICP-AT1000 Dynamic Driver In-Ear Monitor are equipped with 8.5mm moving-coil, single dynamic drivers.

Powered and tuned by Final Audio Design, the BAM (Balancing Air Movement) technology optimizes airflow inside the housing and efficiently controls unwanted vibrations, which results in a deep and rich listening experience.

The headphones deliver a clear bass response and provide smooth treble and transparent mids. They are equipped with a noise-eliminating cable, built-in mic, and a 4-pole, 3.5mm TRRS jack.