(9:00AM to 5:00PM)
The APM 2.5 Power Module is a simple way of providing your APM 2.5 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 6S LiPo battery. The Power Module comes completely assembled with Deans connectors, and wrapped in shrink tubing for protection.
Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It isnotdesigned to power servos. Use your aircraft s own ESC/BEC for that.
Notice:
we have many buyer burned this cable when connet it to 6S battery because he solder the cable to our this module cable.please don t connect or solder any other cable on this current cable,otherwise it will be burned Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable.
The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery .
Special for APM2.5.2 APM2.6 Pixhawk flight controller.
Specifications:
Max input voltage: 28V
Max current sensing: 90A
Voltage and current measurement configured for 5V ADC
Switching regulator outputs 5.3V and 3A max
6-pos DF13 cable plugs directly to APM 2.5 s PM connector
Support 6S battery
Package including :
1 * APM Power Module XT60 Plug
If any questions, please do not hesitate to contact us and we will try our best to help you !
